3dscapture.com

You could make the Loopy capture card external, similar to 2DS capture card, by adding an extra housing at the bottom of the New 3DS. Defeats the appeal of the New 3DS. IIRC one of the issues was figuring out where to put the USB C port, and he thought replacing the charge port was probably the way...

ChemNation wrote: ↑

Fri Apr 26, 2024 10:51 pm

Looks there there are no wires. Does anyone know what gauge wires are used for the usb charging?

28 awg solid core wire. You can use larger if that's what you have.

It's fine to do so on the first batch (I had one). If the USB port is blue, red, and/or has the SuperSpeed logo on it, it'll be fine. If you're going to use a USB hub, use one that is externally powered to be safe. You can also charge it to full and it'll consume less power.

It'll work. I haven't tried the screen swap mod though. Would be cool if you could have the top screen maximized on the monitor, bottom screen in hand, and swapping between the two.

https://bitbuilt.net/forums/index.php?t ... ping.1675/

Yes. It also has crop options for both DS scaling options.

Not much different from doing a reshell without a capture card, you'll just have to be careful when removing the capture board with the adhesive. Use something thin and flat and slowly work through the adhesive. You have to do this to disconnect the antenna. Follow the install guide for where to cut...

Yeah just run the program twice and it'll automatically handle it.

Both are the same speed (USB 2), so just pick the one that suits your setup. Or go with no cable and buy a USB 3 Type-C (other end can be whichever) for the best compatability, especially if you have a lot of USB 2 devices or a finicky device like an old audio interface.

Have the same issue with one that I bought broken. No idea what the cause is.

It should be fine if you remove it, but you'll still have the cutout from the katsukity board unless you get a replacement back cover.

What's wrong with it?