Search found 6 matches
- Mon Sep 04, 2023 4:49 pm
- Forum: Tech Support
- Topic: OBS Glitchy Audio + Video
- Replies: 1
- Views: 733
Re: OBS Glitchy Audio + Video
Try using a different port and maybe a different USB cable. Other users have reported doing that to resolve their issue.
- Fri Sep 01, 2023 3:11 am
- Forum: Tech Support
- Topic: Part Replacement Concerns
- Replies: 1
- Views: 748
Re: Part Replacement Concerns
Replacing the lower screen for the New 3DS XL is not that hard. I think with the capture card installed, you'd have to be careful with how you remove the ribbon cables, being careful not to damage any of the connectors. You're gonna have to detach the ribbon cables that go from the capture board to ...
- Fri Sep 01, 2023 12:48 am
- Forum: Tech Support
- Topic: question about n3dsxl self install and issue with the guide
- Replies: 3
- Views: 825
Re: question about n3dsxl self install and issue with the guide
Yes, that ribbon cable with the holes is meant for audio to pass through the USB-C cable. I also tried soldering the ribbon cable myself but found it kicking my butt (I'm very much inexperienced as well when it comes to soldering), but it's not fully required if you're willing to use a 3.5mm audio c...
- Wed Aug 16, 2023 1:47 am
- Forum: Tech Support
- Topic: Loud buzzing noise in recorded audio?
- Replies: 2
- Views: 1032
Re: Loud buzzing noise in recorded audio?
Have you considered trying a Ground Loop Noise Isolator? I used one to remove the static from the audio, and it works like a charm too. I know you found a solution, but I'm just throwing it out there.
- Sun Jun 25, 2023 2:47 am
- Forum: General
- Topic: Jig for drilling USB-C hole
- Replies: 13
- Views: 15478
Re: Jig for drilling USB-C hole
I saw a couple of these USB-C jigs on Ebay. Have you checked those out by chance? I never tried them, myself.
- Mon Jun 19, 2023 3:31 am
- Forum: Tech Support
- Topic: I messed up the USB-C port (Resolved!)
- Replies: 0
- Views: 5699
I messed up the USB-C port (Resolved!)
Hello, as the title says, I messed up the USB-C port on the capture board, and now it's partially destroyed (where you would connect the cable), with no way to connect to the computer. Is there a part number I can refer to so I can solder in a new port? Update August 1st: Loopy fixed the capture boa...