3dscapture.com
http://3dscapture.com/forum/

Recommended Wire Gauge
http://3dscapture.com/forum/viewtopic.php?f=6&t=2869
Page 1 of 1

Author:  Dysproh [ Sun Apr 09, 2017 11:36 pm ]
Post subject:  Recommended Wire Gauge

So, I just ordered a controller mod for my 2ds. I have some 20 awg wire, but I am afraid that is a bit too thick. What gauge of wire should I use to ensure it fits and that it is still able to transfer enough current to work?

Author:  Tecd0c [ Mon Apr 10, 2017 1:11 am ]
Post subject:  Re: Recommended Wire Gauge

You should use AWG 32.

Author:  PurpleFyrus [ Sat May 27, 2017 9:57 pm ]
Post subject:  Re: Recommended Wire Gauge

Would this be a good example of what to buy? :
http://www.ebay.com/itm/Magnet-Wire-32-AWG-Gauge-Enameled-Copper-2oz-611ft-200C-Magnetic-Coil-Winding-/251137784500?hash=item3a78fa7ab4:g:E6cAAOSwTZ1XlpAN

Or should I invest in something higher in quality?

Author:  Tecd0c [ Sat May 27, 2017 11:09 pm ]
Post subject:  Re: Recommended Wire Gauge

Better get Kynar this is then single wire and coated too.

Author:  PurpleFyrus [ Sat May 27, 2017 11:59 pm ]
Post subject:  Re: Recommended Wire Gauge

Ah, thanks.

So is this more on track?
https://smile.amazon.com/uxcell-B-30-1000-Colored-Insulation-Wrapping/dp/B00GWFECWO/ref=sr_1_1?ie=UTF8&qid=1495929347&sr=8-1&keywords=kynar+wire+30+awg

Author:  Tecd0c [ Sun May 28, 2017 2:07 am ]
Post subject:  Re: Recommended Wire Gauge

close, but not kynar, that isulation plastic is going to melt as soon it get's heated up..
and I would get it as AWG 32.

Author:  PurpleFyrus [ Thu Jun 01, 2017 4:33 am ]
Post subject:  Re: Recommended Wire Gauge

Okay, last post (hopefully haha), sorry for the multiple requests on feedback.

I found this which I believe is Kynar, but is sadly 30 awg: http://www.awcwire.com/productspec.aspx?id=ul-1422-kynar

If I could get a custom order of 32 awg, think this would be suitable?

Author:  Tecd0c [ Fri Jun 02, 2017 9:39 am ]
Post subject:  Re: Recommended Wire Gauge

To do the install you will have to route it from the bottom side of the board, so AWG 30 is too stiff...

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/