Hi Loopy,
Hope I can reach you from here. I started trimming a USB-C port for my N3DSXL, but noticed this image a bit too late:
https://www.3dscapture.com/install/20.jpg
It seems I need to trim this whole area just for the capture card to fit inside. Is this true?
If yes, can I just order a pre-trimmed shell instead of sending my unit over?
Thanks!
Bought the self-install N3DSXL kit, but had problems installing
-
- Posts: 6
- Joined: Thu Jan 05, 2023 5:48 pm
-
- Posts: 6
- Joined: Thu Jan 05, 2023 5:48 pm
Re: Bought the self-install N3DSXL kit, but had problems installing
If not, could I ask what machine you used to trim the shell?
I'd like to ask if I can get a copy of the code/command specific to trimming the 3DS shell via your trimmer, then give that file to my brother.
My brother is a machinist, and trims and shapes metal at his work. Dunno what machine he uses tho.
I might ask him if he could trim my N3DSXL shell.
Thanks again!
I'd like to ask if I can get a copy of the code/command specific to trimming the 3DS shell via your trimmer, then give that file to my brother.
My brother is a machinist, and trims and shapes metal at his work. Dunno what machine he uses tho.
I might ask him if he could trim my N3DSXL shell.
Thanks again!