Replace Katsukity Board with Loopy Board

[Czarcasm]

May be a stupid question but I have a New3dsXL capture card that recently failed that I got installed by Delfino Customs a few years ago since I don't think anyone else was working on N3dsXL yet. Is it possible to get it replaced by a Loopy board or is it not possible for some reason due to how the Katsu Board was installed?

[Elysium]

It should be fine if you remove it, but you'll still have the cutout from the katsukity board unless you get a replacement back cover.

What's wrong with it?

[Czarcasm]

I can't seem to get it to work with the capture program anymore, it's just stuck on "Initializing the capture device" and if I restart the program it says "Capture Device not found" until I unplug and plug it back in again. I've tried changing usb ports, usb cords, rebooting, etc.

[Elysium]

Have the same issue with one that I bought broken. No idea what the cause is.

[Tecd0c]

Your PRAM got corrupted. This happens in two scenarios.

Defective USB port - semi bricked, if you move the cable it connects/disconnects.. then the upload of the micro firmware is interrupted in middle and corrupts the PRAM.

You are using a second Keity system simultaneously, so the wrong micro code gets uploaded.
Contact me for service...