3dscapture.com

I wanted to know what technique people used to seal the stylus hole. Also, is it necessary to seal the small hole next to the stylus hole? (the one right under where the usb connecter is)

Thanks!!

I covered the holes with tape on the outside of the shell, and then filled it in with two-part white epoxy, namely Araldite. This way the hole was completely filled in and the epoxy sat flush with the rest of the outside of the shell. Gave a nice, smooth finish too!

Once it dries fully, you can remove the tape.

The only reason I used white epoxy is because I couldn't find any other/better colour, there's no reason to use a specific colour other than for aesthetics.