3dscapture.com

Managed to burn the flex cable here and there while installing a GBAccelerator, making the capture recognized by the computer, but the image not displaying at all even after trying to resolder each solder points (Connecting the console through usb c still charges it tho)
Since the board itself is fine, I was wondering if buying a flex cable alone for repair was an option over buying a whole new kit

Have a good day!

Not sure if this can help me but this is what the debut window looks like

MousSe wrote: ↑

Thu Dec 01, 2022 3:21 pm

Since the board itself is fine, I was wondering if buying a flex cable alone for repair was an option over buying a whole new kit

I'll send another one.

MousSe wrote: ↑

Thu Dec 01, 2022 3:31 pm

Not sure if this can help me but this is what the debut window looks like

The newer software version might tell you more.

The newer software version might tell you more.

This is the output on the newer version

I'll send another one.

In case it not fixable, how would we go about this? (price etc)

MousSe wrote: ↑

Fri Dec 02, 2022 11:11 am

This is the output on the newer version

Check the soldering on the DCK point.
https://3dscapture.com/ds/install/20.jpg

MousSe wrote: In case it not fixable, how would we go about this? (price etc)

It's already sent.

loopy wrote: It's already sent.

holy shit that was quick
thank you so much

how are you sure where to send it and stuff tho?

I can see your email address here. Easy enough to match that with your order...