Page 1 of 1
3ds charging cradle
Posted: Tue Oct 10, 2023 6:50 pm
by wdoconnell
Has anyone had any success in modifying the charging cradle for the 3ds to fit the chunkier size of the loopy-modded 3ds? Was going to take a stab at doing this myself and wanted to see if others had tips.
Re: 3ds charging cradle
Posted: Wed Oct 11, 2023 6:31 pm
by TheAllStarsGuy
wdoconnell wrote: ↑Tue Oct 10, 2023 6:50 pm
Has anyone had any success in modifying the charging cradle for the 3ds to fit the chunkier size of the loopy-modded 3ds? Was going to take a stab at doing this myself and wanted to see if others had tips.
I assume it's the original model 3DS, CTR-001, correct? If so, then it's probably nothing that a little 3D modeling and printing couldn't do. I'm not an expert on this sort of thing, so I apologize if that's not the best answer I could give.