OGDS board suddenly stopped capturing

[robochicken7]

Self installed solder board. My other ones are working fine.

Streamed with it two days ago and it worked just fine, but today it will not output any capture. It charges just fine through the USB C port and windows recognizes it when its plugged in (I hear the USB connected noise).

Steps I've tried:
Using the old DS capture software with it
Using different cables
Restarting PC
Plugging in to different USB ports on my PC
Opened it up and looked at the ribbon cables - everything was fine, I even unplugged and replugged all of the required ones.

Steps I haven't tried:
Trying on another PC to see if it's a PC Issue. I don't think it is, as I just built this new PC and had it working fine for a stream two days ago

I don't know what could be wrong with it and any help would be appreciated.

[loopy]

Does the software recognize that it's connected?

[robochicken7]

3ds capture software is saying "Not connected" for that DS.

EDIT: On a side note, my Fiancee's capture board is working alongside my other 3, so I'm still set for Safari week (And I'm now almost100% positive its an issue with the board and not a USB controller issue)